AA-D-600 Door, Vault, SecurityThis specification covers security vault doors which are designed to conform to the minimum standards for physical security equipment as required by the Information Security Oversight Office Directive governing the safeguarding of national security information. The doors provide protection against unauthorized entry for the periods of time specified in 1.2.1.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16

AA-D-600D

(d) The manufacturer or his representative will not be permitted to observe the actual tamper resistance tests conducted on his product at the testing facility. However, when samples tested fail to comply with the requirements of this specification, the sample may be examined by the manufacturer or his representative and full details of the failure may be made known to them in a manner which, for reasons of security, will be in the best interest of the Government.

4.4.4 Test samples. Qualification test sample representative of the classes, types and designs of the class the supplier proposes to furnish shall be forwarded at a time and to a place designated by the General Services Administration. During testing, in the event the sample is destroyed or damaged to such an extent that the testing cannot be completed, the Government reserves the right to require the manufacturer to furnish additional samples to complete the testing.

4.4.5 Drawings and material specifications. The manufacturer shall furnish two complete sets of construction and assembly drawings and material specifications with the sample submitted for qualification. When samples have been tested and are approved for inclusion on the applicable

QPL, the manufacturer shall furnish three additional complete sets of the assembly and construction drawings and material specifications lists to the General Services Administration for the Government's use in inspection and acceptance of the product after award of contract. All material so furnished by the manufacturer will be held in proprietary confidence.

4.4.5.1 Changes in drawings and material specifications. Once the door has been tested and approved for QPL, no change of any kind shall be made in its construction or in the construction drawings unless prior written authorization to make the change is obtained from the Federal Supply Service, General Services Administration. Upon receipt of a request for a change, the General Services Administration will determine whether additional testing is required for approval.

4.4.6 Qualification testing. Qualification testing shall consist of the following tests and inspections. Failure of the sample to withstand these tests shall provide reason to consider the product as having failed to meet qualification requirements.

(a) Inspections - 4.4.9 (b) Door test - 4.4.8.1

(e) Finish Test - 4.4.8.4

(f) Escape Device Operational Test - 4.4.8.5

4.4.7 Acceptance after award of contract. The Government reserves the right to inspect and test each door, including all component parts thereof, delivered for acceptance under this specification after award of contract.