AA-C-2859A
3.6.2 Finishing. The final coat shall be applied to all exterior and interior metal surfaces except plated metal. The minimum total finished film thickness of the final coat shall be not less than 0.025 mm. The final coat shall level out to produce uniform exposed surfaces without
runs, grit or other foreign matter, areas of thin film or no film, and without separation of color. Special attention shall be given to the base and interiors to insure that all surfaces are adequately protected against rust. The final finish shall withstand the test in 4.4.8.5 without evidence of cracking, flaking, or loss of adhesion of the finish. Two test panels of 0.91 mm steel in 76 by 127 mm size shall be furnished for purposes of the test. One panel shall be prepared to reflect the inner coating and one to reflect the outer coating used.
3.6.3 Bolts, screws, and nuts. Bolts, screws, nuts, and similar hardware shall be made to resist rust by electrogalvanizing or by zinc coating, cadmium, or chromium plating as specified in 3.2.3 and 3.6.2. A thread locking compound shall be used on all bolts, nuts and screws.
3.7 Lubrication. All of the cabinet's moving parts requiring lubrication shall have a lubricant applied which is suitable to the varied climatic conditions likely to be encountered during the service of the cabinet.
3.8 Forced entry. Cabinets shall be tested as specified in 4.4.8.4, and the forced entry protection afforded by the cabinets shall be for not less than the periods of time specified hereunder.
Class 5 - 10 man-minutes against forced entry.
3.9 Identification labels. Each cabinet furnished by contract or order under this specification shall bear metallic labels as specified hereunder. The GSA label and cabinet number label shall be attached with a durable adhesive or either two rivets or two drive screws.
3.9.1 GSA label. The label shall be affixed to the outside surface of the door. The label shall have a silver background and red letters not less than 3.2 mm in height. The label shall show the following:
GENERAL SERVICES ADMINISTRATION APPROVED WEAPONS CONTAINER (Weapons Storage Only) MANUFACTURER'S NAME
AA-C-2859
3.9.2 Cabinet identification and contract number. This label or labels, shall be affixed to the inside face of the door. The label shall show in easily read letters, the manufacturer's name
and address, the cabinet's model and serial numbers, date of manufacturer, and the
Government contract number.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business