A-A-2122F
a gap greater than 1.16 mm.
- Leaves are not firm, or not resting in a
vertical position against the legs when in a
dropped position.
Identification- Not as specified, missing, mutilate, or
Label: illegible.
Performance: - The stand failed the chromium plating test
requirements of the CID.
- The stand failed the leaf levelness and
support test.
- The stand failed the service test requirements
of the CID.
Any of the above found by inspection shall be considered
grounds for rejection.
4.5 Minor defects. Non-conformance listed below shall be considered as minor defects affecting the appearance of the finished item.
Minor Defects
Reference Defects
Finish: - Rough or slivered surface.
- Burrs.
- Rough tool markings.
- Oversized holes.
- Pitted, stained, or blistered surfaces.
- Foreign matter embedded in the finish.
- Painted surfaces contain sags or runs.
- Parts, components, covered with film, not free
of grease, dirt, dust, epoxy, stains, etc.
4.6 Sampling for inspection. The sampling plan shall be in accordance with MIL-STD-105 with an inspection level II, Acceptable Quality Level (AQL) of 6.5 percent defective for minor defects and an inspection level of S-2, AQL of 2.5 percent defective for major defects.
4.7 Service test. A reciprocating drive device shall be attached to the top center of the stand. The attachment shall allow the stand to rotate freely on its vertical center axis. Distribute 45.3 kg evenly on the top of the stand. Place the stand on the obstacle layout detailed in figure 1. The device shall push the stand 762 mm forward and pull it 762 mm backward over the obstacles, continuously at a rate of 10 to
15 cycles per minute for 10,000 cycles. One cycle is a forward
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business