A-A-2095D
Exceptions to BIFMA American National Standard X5.5 – 1989. Section 13.2.2, 13.2.3, 14, 15, 16, 17, 18, and 19 are not applicable.
Level test for top. The test unit shall be located on a flat surface. Place a steel straight-edge on edge, diagonally (corner to corner) across the top. The length of the straight-edge shall be greater than the diagonal length of the top. There shall be no gap between the straight-edge and top greater than 3 mm at any point along the diagonal length of the top. This test shall be performed along both diagonals of the top before and after performing along both diagonals of the top before and after performing the top loading test specified in BIFMA.
Chromium plating test. Plated samples shall be tested for corrosion in accordance with the 5 percent neutral salt spray at 35O C in accordance with ASTM Test Method B-117. Test period shall be not less than 48 hours. After the specified exposure is completed, the specimen shall be visually examined to assure that the plating shows no evidence of peel, chip, uneven color, powder film, pits, or stain. Widely scattered spots of corrosion are permitted, however, none of these spots shall exceed 1.6 mm long the greatest dimension.
Regulatory Requirement. The offeror/contractor is encouraged to use recovered materials in accordance with Public Law 94-580 to the maximum extent practicable.
Preservation, packaging, packing, labeling, and marking. The preservation, packaging, packing, labeling, and marking shall be as specified in the contract or order.
Standards. The issues of ANSI/BIFMA X5.5, MIL-STD-105, and Fed Std 595 in effect on the date of the solicitation shall be used to determine compliance with the stated requirements.
Notes.
Purchaser should specify type, style, size, and color.
Plastic laminate panel. A sample of the decorative plastic laminate sheet is available from the General Services Administration, Federal Supply Service, National Furniture Center, Engineering Division, Washington, DC 20406.
Color panel. A sample of the baked enamel finish referenced in
|| Page 5 End ||
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business