A-A-2240
Accessories
1. Turntable. Turntable shall rotate a minimum of 350 degrees and shall be
18” x 24” minimum. It shall have radius corners and a positive stop to prevent
tangling of cables.
2. Tilting platform. Tilting platform shall have radius corners and shall tilt
3 degrees forward and 15 degrees backward, minimum and shall be 24”W by 18”D,
minimum.
3. Fillers. Fillers shall be constructed and laminated the same as the task
table tops and shall be of the following shapes:
a. Angle to connect two 30”D task tables at 120”
b. Angle to connect two 24”D task tables at 120”
c. Angle to connect two 30”D task tables at 135”
d. Angle to connect two 24”D task tables at 135”
e. Square to connect three or four 30”D task tables.
f. Square to connect three or four 24”D task tables.
g. Nominal 24” x 30” rectangle to connect 30”D and 24”D task tables at 90
degrees.
Note. The (e) square and the (f) square fillers shall not be
used to connect only two tables. The corner may be filled by either a type IV
corner table or by ordering a longer table to butt against the other table to
form the “L” arrangement.
Assembly. Task tables, keyboard shelf and fillers shall include
corrosion resistant hardware for complete assembly with simple hand tools.
Simple illustrated instructions for assembly shall be included.
Identification label. The label shall have the contractor’s name or
trademark, contract or order number, National Stock Number (if specified) and
month and year of manufacture legibly marked in permanent dark ink. The labels
shall be affixed under the top of the stand and on the bottom of all other
items and shall not be removable by hand without defacement after being affixed
for 4 hours.
Workmanship. The workmanship shall be of the quality to produce finished
items acceptable in appearance, function and serviceability and to prevent
potential hazard to personnel or their clothing.
Performance. Each unit shall comply with the following requirements.
Failure of any unit to comply with these requirements shall be cause for
rejection.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business