Tops. Tops shall be covered with HP plastic laminate
with backing sheet ion bottom (steel cores excepted), walnut grain per GSA
Standard Sample No. FSS-L-01002, light oak grain per GSA Standard No.
FSS-L-01015 or matte parchment laminate within the limits of the parchment
enamel. Alternatively, the manufacturer may provide his equivalent walnut or
light oak grain HP plastic laminate subject to the contracting officer
approval. Molding, if used, shall have radius corners and shall match the baked
enamel finish within the limits of the material used. Overall thickness shall
be 1” minimum. Self edge is not allowed on the front or back edges of the
tops. Adjustable tops shall have a minimum range of infinite adjustability
from 25 1/2” high to 30” high (glides fully retracted). The adjusting mechanism
shall not interfere with work tasks or mobile pedestals and shall be accessible
from an operating position. Holes shall be provided to allow attachment of the
keyboard shelf in the middle and each side of the height (b) 29-1/2” task tables.
Disassembly of the top from the base by removal of screws directly screwed into
composite tops is unacceptable.
Base. The base shall be metal with 4 corrosion resistant adjustable
glides. Metal or laminate modesty panel (10 1/2 “H minimum) across the back.
Full panels and conventional table legs not acceptable. To allow mobile
pedestals to be used, Depth (a) units shall have a minimum clear space of 20”
from the front to the inside of the modesty panel and Depth (b) units shall
have a minimum clear space of 24” from the front to the inside of the modesty
panel. No obstructions, such as shelves shall be allowed. Minimum space between
legs shall be 31” on Width (a) 43” on Width (b) 55” on Width (c) and 67” on
Width (d). The finish shall be semi-gloss baked enamel with colors Fed. Std.
No. 595 black (27040) or parchment within the range delimited by (26586) and
(26405). Alternatively, the manufacturer may provide his commercial black baked
enamel finish subject to the contracting officer approval.
Wire management. Wire management openings shall be a minimum of 3 square
inches in area, located on each side of the rear third of the top. The openings
shall have collars and removable covers. One opening required for Width (a). A
trough or channel beneath the top surface shall allow routing of wire across
the table.
Keyboard shelf. The keyboard shelf shall have radius corners and shall
retract under the top and have a minimum adjustable clearance from 2” to 3
1/2". The clear usable surface when fully extended shall be 21-1/2”W by
9”D minimum. The design shall allow the shelf to be held in position in both
the end in and out position.
|| Page 2 End ||
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business