A-A-2082D
laminate with a backing sheet on the bottom. The backing sheet is not required with steel core tops. The sides of the top shall be sealed or self-edged. Overall thickness of the top shall be a minimum of 19 mm. alternatively, the top and drop leaves may be five ply hardwood lumber core or seven ply hardwood veneer, properly sealed on both sides and finished with semi-gloss lacquer.
3.1.3 Plastic laminate. When a HP plastic laminate is used, the color shall be white leather in accordance with GSA Standard FSS-L-01001. Alternatively, the manufacturer may provide his equivalent commercial white leather HP plastic laminate subject to the contracting officer’s approval.
3.2 Legs.
3.2.1 Type I legs. The type I legs shall have be a minimum 50 mm square (with or without a taper) formed steel and shall be KD construction.
3.2.2 Type II legs. The Type II legs shall be tubular or formed steel. The base shall have retractable casters, minimum 50 mm diameter with ball bearing swivels, the retracting mechanism shall have a mean of locking the casters in the down or operating position.
3.3 Drawer or compartment. On the Type I stand, there shall be either a drawer or an open compartment located on the right facing the stand. Either shall accommodate 216 mm by 279. 4 mm paper. The sides of the open compartment shall be closed and shall be equally accessible from the front or back of the stand. Exposed corners shall have a minimum 12.7 mm radius, minimum inside clearance height of the drawer or compartment shall be 50 mm. The drawer shall have in and out stops.
3.4 Finish. The stand shall have a baked enamel finish. The color shall be in accordance with Fed.Std.No.595, gray (26134). Alternatively, the manufacturer may provide his commercial, baked enamel, gray finish subject to the contracting officers approval.
3.5 Identification label. The identification label shall have the contractor’s name or trademark, contract number and year and month of manufacture legibly marked with permanent ink. The label shall not be removable by hand without defacement after being affixed for four hours.
3.6 Workmanship. The stands shall be free from sharp
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business