close and extended positions.
Drawer and door pulls. The finish shall be polished, chrome plate on steel, die-cast zinc, brass or bronze; polished stainless steel; or polished anodized aluminum.
Adjustable shelf. The shelf shall be formed on all four sides. Shelf adjusting devices shall not be visible on the exterior of case. Shelf supports shall be provided. Minimum dimensions shall be 620 mm W X 380 mm D.
TABLE I Drawer dimensions.
|
Drawer type |
Minimum inside clear dimension |
||
|
Width |
Height |
Depth |
|
|
Storage drawers |
288 mm |
130 mm |
280 mm |
|
File drawers |
300 mm |
250 mm |
350 mm |
Legs. Legs shall be attached to the underside of the credenza pedestal or end panel. The legs shall be equipped with adjustable glides.
Finish. The finish shall be baked enamel. The color shall match Fed. Std No. 595 gray (26134). Alternatively, the manufacturer may provide his equivalent commercial, gray, baked enamel finish, subject to contracting officer approval.
Identification label. The label shall have the contractor’s name or trademark, contract number, National Stock Number (if specified), and month, and year of manufacture legible marked with permanent dark ink. The label shall be applied to the back of the credenza and shall not be removable by hand without defacement after being affixed for 4 hours.
Workmanship. The workmanship shall be of the quality to produce finished credenzas acceptable in appearance, function and serviceability and prevent potential hazard to personnel or their clothing.
Quality Assurance Provisions. Unless otherwise specified in the contract or purchase order, the contractor is responsible for
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business