A-A-2009E
requirements referenced infections l,2and3 have been met. Any non-conformance with the above requirements shall be considered a defect. All defects found shall be classified as major/minor in accordance with paragraphs 4.4 and 4.5 of this CID.
4.4 Major defects. The following conditions of non-conformance with the stated requirements of the CID shall be considered as major defects which may potentially affect the safety, functionality, durability, usability, and life of the purchased items.
No acceptable evidence of meeting ANSU/BIFMA X 5.5 tests.
Unacceptable evidence of meeting ASTM Test Method B 117.
Parts fractured, buckled, bent, punctured, or malformed.
Rivets loose or not set properly.
Sharp edges.
Preservation, packaging, and packing not in accordance with the requirements of the contractor purchase order.
Identification marking missing, wrong, or illegible.
4.5 Minor defects. Non-conformance listed below shall be considered as minor defects affecting the appearance of the finished item.
Rough or slivered surface.
Burrs.
Rough tool markings.
Oversized holes,
Pitted, stained, or blistered surfaces,
Foreign matter embedded in the finish.
Painted surfaces contain sags or runs.
Components and pats covered with film.
Parts, components, overall covered, not free of grease, dirt dust, epoxy, stains, etc.
4.6 Sampling. The sampling plan shall be in accordance with ANSI/ASQC Z1.4 with an inspection level II,
Acceptable quality Level (AQL) of 6.5 percent defective for minor defects and an inspection level of S-2, AQL of 2.5 percent defective for major defects.
5. REGULATORY REQUIREMENTS. The offeror/contractor is encouraged to use recovered materia1sin accordance with Public Law 94-580, as amended, to the maximum extent practicable.
6. PACKAGING. The preservation, packaging, packing, labeling, and marking shall be ns specified in the contract or order.
7. NOTES.
7. Intended use. The files covered by this document are intended to be used for general office duty
7.2 Ordering data. Purchasers shall specify the
(a) Title, number, and date of this Commercial Item Description
(b) Type
(c) Size
(d) Marking
(e) Color
7.3 Standards. The latest issues of ASTM B 117, ANSI/BIFMA X 5.5, ANSI/ASQC Z1.4, and Fed. Std. 595 in effect on the date of the solicitation shall be used to determine compliance with the stated requirements.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business