A-A-1709H
the top compartment advising users to; level the cabinets from side to side with the front higher than the back, (where applicable); load the bottom compartment first; read the instruction sheet for installation and conversation of accessories from letter to legal size filling. These labels shall not be removable by hand without defacement after being affixed for 4 hours.
Identification label. The label shall have the contractor’s name or trademark, contract number, National Stock Number (if specified), month and year of manufacturer legibly marked in permanent dark ink. The label shall be located in the top compartment and shall not be removable by hand without defacement after being affixed for 4 hours.
Workmanship. The workmanship shall be of the quality to produce finished cabinets acceptable in appearance, function and serviceability and to prevent potential hazard to personnel or their clothing. Welding and brazing shall be neat, uniform, free of burrs and adequate to assure rigidity and strength.
. The workmanship shall be of the quality to produce finished cabinets acceptable in appearance, function and serviceability and to prevent potential hazard to personnel or their clothing. Welding and brazing shall be neat, uniform, free of burrs and adequate to assure rigidity and strength.
Quality assurance provisions. Unless otherwise specified in the contract or purchase order, the contractor is responsible for the performance of all inspection requirements specified herein. Sampling for Inspection shall be performed in accordance with ANSI/ASQC Z1.4, unless an equal or better plan is approved by the contracting officer or his/her representative. A lot shall be one each. Inspection levels and AQL’s shall be as follows.
For fit, finish and all other workmanship – Level II, AQL 4.0 defects per hundred units.
For packaging, packing and marking – Level S-2, AQL 4.0 percent defective.
Any failure to meet the dimensions, color, identification, label or performance requirements shall cause rejection of the lot.
Performance. Each unit shall comply with the following requirements. Failure of any cabinet to comply with these requirements shall be cause for rejection.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business