A-A-2242
Identification label. The label shall have the contractor’s name or trademark, contract or order number, National Stock Number (if specified) and month and year of manufacture legibly marked in permanent dark ink. The labels shall be affixed under the top of the stand and on the bottom of all other items and shall not be removable by hand without defacement after being affixed for four hours.
Testing. Mobile pedestal shall be tested in accordance with ANSI/BIFMA Standard for Vertical Files (X5.3-1981, with the following exceptions. Failure of any unit to comply with these requirements shall be cause for rejection.
Section 4 Stability test. Modified for Type I, III and IV units:
Data printout drawers shall be loaded with 2-1/4 pounds per linear inch of inside drawer space. File drawers shall be loaded with 2 pounds per linear inch. The top drawer shall be empty. When the bottom drawer is fully extended, the unit shall not tip.
Section 5, 6, 7, 8 and 9. Casters shall be removed.
Section 10. No follower block.
Section 11. Not applicable.
Caster durability test. The pedestal shall be loaded with two pounds per linear inch in all drawers (not including convenience tray). the complete unit shall be pushed forward and pulled backward over a barrier strip 1/8 inch high, minimum, at a rate of 7 to 10 cycles per minute for 20,000 cycles. One cycle is a forward and backward stroke. Structural failure, damage, deformation or loosening of parts which affect stability or serviceability or could cause personal injury to a user is cause for rejection.
Regulatory requirements. In accordance with the section 23.403 of the Federal Acquisition Regulations, the Government’s policy is to acquire items composed of the highest percentage of recovered materials practicable, consistent with maintaining a satisfactory level of competition without adversely affecting performance requirements or exposing suppliers’ employees to undue hazards from the recovered materials.
Preservation, packaging, packing, labeling, and marking. Preservation, packaging, packing, labeling, and marking shall be as specified in the contract or order.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business