A-A-2093A
Pulls (drawers). The drawer pulls shall be recessed. The finish shall be polished chrome plate on steel or die cast zinc, or polished anodized aluminum.
Secretarial insert. The front of the stationary rack shall be designed to facilitate access. When the slide-out stationary rack design is used, it shall have a latching device to prevent unintentional removal.
Attachment bracket. Each L-return shall be furnished with a bracket complying with Figure 6, and two 1/4-20 x 3/4” low profile slotted head machine screws with nuts and lock washers.
Finish. Baked enamel with Fed.Std.No. 595- black (27040) or parchment with the range delimited by (26586) and (26405). Alternatively, the manufacturer may provide his equivalent commercial black and parchment baked enamel finish subject to contracting officer approval.
Identification label. The label shall have the contractor’s name or trademark, contact number, NSN (if specified), year and month of manufacture legibly marked in dark ink. The label shall be located on the inside of the knee space near the top and back of the pedestal or panel end. The label shall not be removable by hand and without defacement after being affixed for 4 hours.
Workmanship. The workmanship shall be of the quality to produce finished L-returns acceptable in appearance, function and serviceability and prevent potential hazard to personnel or their clothing.
Performance. Each L-return shall comply with the following requirements. Failure to comply with these requirements shall be cause for rejection.
BIFMA. L-return shall comply with the requirements of BIFMA Voluntary Desk Standard D-1-1981, with the following exceptions: The Lock Test, Desk Stability Test, and the Table Stability Test (Sections 6, 13, and 14) are not applicable to this item. Testing in accordance with Sections 4 and 5 shall be conducted with the L-return attached to a Type I, Size 1 desk in accordance with CID-A-A-2095, using the brackets described in A-A-2095 and herein.
10.3- Lines 3, afte “legs” insert “pedestals”
10.3- After “damage” insert or any damage”
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business